Packard Bell Statesman System

Specification

• Battery : 3.6V DC NiCad soldered on motherboard
• BIOS : 128 KB - Phoenix BIOS V1.03
• Bus Architecture : ISA based system bus
• Cache : 1K internal cache on the CLS chip.
• CPU : Cyrix Cx486CLC-33 MHz, Cx486SLC-50MHz
• Interfaces :
  • 1 DB-25 Parallel Port
  • 1 DB-9 Serial port
  • 1 15-pin VGA
• RAM : 4 MB Standard on Motherboard 12 MB Maximum on Motherboard
• Speaker : Piezoelectric soldered on motherboard
• Video : Built in CHIPS 65530 Series

Note - The Statesman 200c Plus is the same as the 200c and the Statesman 200m Plus is the same as the 200m, except the Plus models have Cyrix Cx486SLC2-50MHz CPUs.

Upgrades

• Cache : 1K built into the 486SLC chip, not upgradeable.
• Maths Co-Processor : Cyrix Cx83S87-33MHz math co-processor can be installed in this system.
  • Power off the system and remove the battery.
  • Turn over the computer and remove the math co-processor cover.
  • Align the co-processor chip with the socket so that the beveled edge of the chip (pin-1) matches the beveled edge of the socket (pin-1).
  • Press the chip firmly into the socket until the chip is fully seated on all sides. Replace the math co-processor cover.
• RAM : 4 MB Standard on Motherboard 12 MB Maximum on Motherboard. The mainboard has three memory module sockets that take proprietary SIPPs.
• Video Memory : 512KB Video Memory, not upgradeable.