Packard Bell Houston 3+ M/Board

Gigabyte 'Houston 3+' Motherboard Diagram

Specification

Audio : SigmaTel STAC9700 Codec
BIOS : AMI BIOS.
Chipset : Intel 810 chipset consisting of the Intel 82810 Graphic Memory Controller Hub (GMCH) and the 82801 I/O Controller Hub (ICH).
CPU Support : Socket 370.
- Supports Intel Celeron PPGA processor 366/66, 400/66, 433/66, 466/66, 500/66 MHz and faster.
- Supports Intel PIII Coppermine FC-PGA (Flip-Chip Pin Grid Array) processor 600/100, 650/100, 700/100 MHz and faster.
- Warning: not all the above processors have been qualified by Packard Bell.
- 66/100 MHz Host bus speed processors are supported.
Expansion Slots : 3 PCI slots.
Form Factor : 24.4 x 21.0 cm Form Factor
RAM :
- Up to 256 MB (64-bit technology) or 512 MB (128-bit technology) total memory in one or two DIMM sockets.
- SDRAM 64/128-bit non-ECC DIMMs
- Single or double sided 3.3 V DIMMs, 60 ns CAS Latency 2/3, 66 or 100 MHz SDRAMS.
- The motherboard automatically detects the size and type of the memory used.
Video : Integrated in chipset.

Jumper	Configuration
JP3 - Clear CMOS	1-2 : Normal operation (default) 2-3 : Clear CMOS settings (keep system unplugged for 5 seconds)
JP11 - Set Suspend to RAM	Open: Disable STR (default) Closed : Enable STR
JP26 - Set Flash Memory	1-2 : Normal (default) 2-3 : Restore Settings Open : Recovery
JP22 + JP32 - USB	1-2, 1-2 : Front USB on (default) 2-3, 2-3 : Top rear USB on
JP30 - Set USB Keyboard Wakeup	1-2 : USB keyboard wakeup disabled (default) 2-3 : USB keyboard wakeup enabled
JP31 - Audio CODEC selection	1-2 : Primary 2-3 : Disable CODEC Open: Secondary